Joined in 2023 
82 
63 About this deal
The argument that’s made for their use by The European Centre for Disease Prevention and Control among others is that they could help to limit transmission of the virus in busy public situations where social distancing is difficult, such as public transport or supermarkets. Medical masks in Europe must comply with the European standard EN 14683, which have 3 levels of bacterial filtration efficiency (BFE1, BFE2, Type R). In the US medical masks must comply with ASTM standards, which have three levels of protection (from low risk of exposure to fluids to high risk of exposure to fluids).
COVID-19: A guide to face masks - DentalNursing COVID-19: A guide to face masks - DentalNursing
Type I, and Type I R face masks have a BFE (bacterial filtration efficiency) of 95%, whereas Type II and Type II R face masks have a BFE of 98%. The breathing resistance, and splash resistance for Type I R and Type II R masks, are exactly the same.ISO 22609:2004: Clothing for protection against infectious agents – Medical face masks – Test method for resistance against penetration by synthetic blood (fixed volume, horizontally projected) The UK government is attempting to keep up with a surge in cases of the coronavirus, and has therefore introduced new face mask rules from today, January 4. The wearing of a mask for protection against droplet or splash to the wearer when in close proximity an infected individual (for example, within 2 metres for COVID-19 or influenza).
Transparent face mask technical specification [Withdrawn] Transparent face mask technical specification
The transparent face masks, which are the subject of this specification, are intended to be used in place of the medical masks referred to by the WHO above. In the opinion of the group, a transparent mask complying with the design and performance requirements of this document could therefore perform in a comparable manner to a Type IIR mask for source control.
Materials used shall be suitable to withstand handling and wear over the period for which the transparent face mask is designed to be used. The following documents are referred to in this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. Where the term ‘medical mask’ is used in this specification it is used on the basis of the term used by the World Health Organization (WHO) and EN 14683:2019, but it is recognised that the term ‘fluid resistant surgical mask’ (FRSM) is also in common use. This document makes no distinction between a Type IIR medical mask and an FRSM and the terms can be used interchangeably. 1. Introduction
Consumer Feedback: TSL Face Masks - TSL Healthcare
Class N: no oil resistance. A distinction is made between N95, N99 and N100. The number after the letter indicates the percentage of filtration of suspended particles.Cases of the virus are high and the government hopes that masks will help stop the spread in indoor places in the country, with pupils in schools now having to wear them. If the transparent area cannot be tested to Annex B of BS EN 14683:2019, it shall, when tested to the wet bacterial penetration test in BS EN ISO 22610:2006 (test method to determine the resistance to wet bacterial penetration) have a barrier index (I B) = 6.0. Alternately, it may be tested to other standardised and accepted test methods designed to demonstrate resistance to penetration of microorganisms – for example, ASTM F1671. Within this standard, there are several classes of respirators depending on the degree of oil resistance:
Great Deal 
New Comment